EWP®150 Kit Remote Electric Water Pump (12V) (Part #8060)
The EWP®150 Alloy 12V is available for purchase in the following options:
- Pump Only (Part #8160)
- Kit (Part #8060)
- Combo with Controller (Part #8970)
Muscle up your engine cooling system with the Davies Craig EWP®150 alloy Electric Water Pump. Like all EWP®s, this advanced unit is designed for remote mounting in the engine bay to satisfy those higher horsepower, turbocharged, supercharged, and worked engines which develop excessive heat & intercooler applications.
The compact EWP®150 alloy unit is manufactured with -AN16 ORB internal inlet and outlet fittings for neat, tight screw-in fitting applications. This rugged alloy hi-flow electric water pump is designed to complement or replace the engines existing mechanical water pump. This essential performance accessory increases power to your vehicles drive wheels and improves coolant temperature control.
KIT CONTENTS
| PART DESCRIPTION | UNITS |
|---|---|
| EWP®150 Alloy | 1 |
| EWP® Basic Wiring Harness | 1 |
| Hose Clamps | 2 |
| RED - Wire Joiner | 1 |
| RED - 6mm Ring Terminal | 1 |
| RELAY - 12V 40 Amp 5 Pin W/- Resistor Protection | 1 |
| SCREW - SELF TAP 8X3/8 BZ | 1 |
TECHNICAL SPECIFICATIONS
| Operating voltage | 3V DC to 15V DC |
| Maximum current | 10A @ 13V |
| Flow rate (max) | 162L/min (42.8 US gal/min) @ 13V DC |
| Operating temp. | -40° to 120°C (-40° to 248°F) |
| Pump design | Clockwise centrifugal with volute chamber |
| Pump weight | 1,170 grams (2.6 lb) |
| Pump material | Aluminium (Powder Coated) |
| Burst pressure | 500 kPa (72.5 psi) |
| Seal | Ceramic face seal |
| Self Priming | No, none of our pumps are self-priming |
| Fits hose size | 35mm to 51mm (1.38 to 2) |
| Push-On fitting Size | EWP Inlet & Outlet 38mm with 3mm Sleeve (#8510) 44mm with 6mm Sleeve (#8511) 51mm |
| Internal Fitting | Inlet & Outlet: -16AN ORB |
